BLANKS FOR SUBLIMATION

THESE BLANKS ARE HARD SURFACE BLANKS (NOT APPAREL) FOR SUBLIMATION PRINTING. ALL PRODUCTS ARE AVAILABLE COMPLETELY FINISHED WITH DESIGNS AS WELL.

You can purchase hardware here or at your local craft store - Michaels, Hobby Lobby,

1/6 inch thick Unisub MDF Board

Pressing Instructions:

***** We remove the protective film and clean your substrate and then wrap for it protection before shipping*****

Press image down - substrate up at 400 degrees for

55-60 seconds with medium pressure.

These are recommended settings for sublimation that may need
adjustments based on your press for best results. Sublimation settings will vary depending on your heat press, ink, paper and weather conditions.

These are single sided!

Front side is glossy - back is dark hardboard